screws › machine screws
MS35275-259
Drilled Fillister Head Machine Screw
Description
Fastener Length: 1/4", Hole Diameter: 1/32", Thread: 10-24, Thread Length: 1/4"
Specifications
| Departure From Cited Designator | Material must conform to ships parts control center special quality control provisions |
|---|---|
| Fastener Length | 0.219 inches minimum and 0.250 inches maximum |
| Finish | Passivate |
| Head Diameter | 0.292 inches minimum and 0.313 inches maximum |
| Head Height | 0.123 inches minimum and 0.130 inches maximum |
| Head Hole Configuration Style | Round |
| Head Style | Drilled Fillister Head |
| Hole Diameter | 0.046 |
| Hole Quantity | 1 |
| Internal Drive Style | Slot |
| Length | 1/4 |
| Material | CRES |
| Min. Tensile Strength (psi) | 80000 pounds per square inch |
| Nondefinitive Specification/Std Data | 1 type and 5s style |
| Screw Material | Steel comp 302 or steel comp 303 or steel comp 304 or steel comp 305 or steel comp 316 |
| Screw Material Specification | 66 fed std all material responses |
| Screw Surface Treatment | Passivate |
| Screw Surface Treatment Specification | Qq-p-35 fed spec single treatment response |
| Size | 10-24 |
| Test Data Document | 81349-mil-p-23199 specification (includes engineering type bulletins, brochures,etc., that reflect specification type data in specification format; excludes commercial catalogs, industry directories, and similar trade publications, reflecting general type data on certain environmental and performance requirements and test conditions that are shown as "typical", "average", "nominal", etc.). |
| Thread Class | 2a |
| Thread Diameter | 0.190 |
| Thread Direction | Right-hand |
| Thread Length | 0.136 inches minimum and 0.250 inches maximum |
| Thread Qty | 24 |
| Thread Qty Per Inch (tpi) | 24 |
| Thread Series Designator | UNC |
| Thread Size | 10 |
| Thread Type | N.C. - Coarse |
Cross-reference
Similar parts
Parts with matching key dimensions — often from a different standards family. Candidates for comparison only; verify the full specification before substituting.
- MS35265-59 MS #10-24 · 1/4 in · Drilled Fillister Head · Steel
Looking for a specific part? Use the cross-reference lookup.
Catalog data updated 2026-07-05. Report a data error