bolts › machine bolts
AN7-60
Bolt Shank Drilled
Description
Hex head aircraft bolts are made of high-strength type 4037 or 8740 alloy steel (type 8740 is most commonly used). The bolts are centerless ground and threaded after heat treatment. Minimum tensile strength 125,000 PSI. Cadmium plated per specification QQ-P-416A, Type II, Class 3. Available with shank drilled for cotter pin or undrilled for stop nut application, and with or without drilled head for safety wire. Specify bolts to have undrilled shank by adding letter "A" after the dash number. For bolts with drilled head add letter "H" after the AN number. See illustrated examples. "C" represents Type 431 Stainless Steel (contains iron which is magnetic). The length of AN aircraft bolts is measured from under the head to the end of the shank. The "grip" is the unthreaded portion of the shank. See table for conversion of length and/or grip to proper AN callout. Note: Drilled bolts listed above are drilled shank only. To order drilled head only or both drilled head and shank bolts, please use our AN Bolt Selector by clicking the link below
Specifications
| Distance From Head Largest Bearing Surface To Shank Hole Center | 5.922 inches nominal first hole |
|---|---|
| Fastener Length | 6.094 |
| Features Provided | Finished head |
| Grip Length | 5 7/16, 5.438 |
| Hardness Rating | 26.0 rockwell c minimum and 32.0 rockwell c maximum |
| Head Height | 0.234 inches minimum and 0.266 inches maximum |
| Head Style | Hexagon Head |
| Length | 6 3/32 |
| Material | Steel |
| Material Specification | Mil-b-6812 mil spec all material responses |
| Min. Tensile Strength (psi) | 125 pounds per square inch |
| Nominal Length | 6 3/32 |
| Shank Unthreaded Hole Diameter | 0.106 inches nominal first hole |
| Surface Treatment | Cadmium and chromate |
| Surface Treatment Specification | Qq-p-416,type 2,class 3 fed spec single treatment response |
| Thread Class | 3a |
| Thread Diameter | 0.438 |
| Thread Direction | Right-hand |
| Thread Length | 0.656 inches minimum |
| Thread Qty | 20 |
| Thread Qty Per Inch (tpi) | 20 |
| Thread Series Designator | UNF |
| Thread Size | 7/16 |
| Width Between Flats | 0.615 inches minimum and 0.627 inches maximum |
Cross-reference
No interchangeable or dimensionally similar parts are on record for AN7-60. Try the cross-reference lookup to search by a different part number.
Catalog data updated 2026-07-05. Report a data error